The Commercial Rang Hood Rectangular, 1 to 6 m, with a 1-meter overhang captures smoke, grease and cooking vapours over a length of 1 to 6 metres, with a 1 m overhang suited to kitchens requiring a large catchment area. Built in France, it can be installed as a wall-mounted hood or as an island hood.
Technical specifications
| Specification |
Value |
| Lengths available |
1, 1.5, 2, 2.5, 3, 3.5, 4, 4.5, 5, 5.5 and 6 metres |
| Depth |
1000 mm |
| Height |
450 mm, front drop of 450 mm |
| Overhang |
1 m |
| Filtration |
Stainless steel baffle filters, blanking plates and stainless steel spacers |
| Grease tray |
With drain plug |
| Manufacturing |
France |
| Warranty |
1 year |
| Product weight |
From 45 kg, varies according to the length chosen |
| Package weight |
90 kg |
Static extraction hood without motor: use and assembly
This rectangular hood is a static hood, supplied without a motor: it captures and contains air laden with grease and smoke, but requires a double-inlet centrifugal fan, an extraction fan box or a roof extract fan to provide extraction. It is available as a wall-mounted version, fitted against a wall, or as an island version above a cooking suite. The air outlet hole is not pre-drilled at the factory: it is to be made on top, at the rear or on one side of the hood, depending on the type of fan chosen. If the fan is built into the hood (up to 3 m in length), its position and that of the outlet should ideally be centred.
Filters and outlet diameter according to length
The number of baffle filters and the outlet diameter required depend directly on the hood length chosen, as a guide only and depending on the extraction ductwork installed:
- 1 m hood: 1.5 baffle filters, outlet to be drilled at D200 or D250 mm
- 1.5 and 2 m hood: 2 baffle filters and blanking plates, outlet to be drilled at D250 or D315 mm
- 2.5 m hood: 3 baffle filters and blanking plates, outlet to be drilled at D315 or D355 mm
- 3 m hood: 4 baffle filters and blanking plates, outlet to be drilled at D355 or D400 mm
Beyond 3 m, the hood is supplied in 2 modules assembled on site: for example, the 4 m length corresponds to two 2 m modules, and the 6 m length to two 3 m modules. A junction hole between the two modules must be made during assembly. The exact composition of the modules according to the length ordered depends on stock availability at the time of order.
Installation and connection
The hood is supplied flat-packed in cardboard, in 1 or 2 modules depending on the length, ready to assemble. Assembly instructions are available for download. VentilSoGood supplies the equipment without carrying out installation: assembly and connection to the extraction ductwork must be carried out by a professional.
Points to check before ordering
- Hood length required according to the size of the cooking line to be covered (1 to 6 m available)
- Desired location for the outlet hole (top, rear or side), which determines the choice of fan and its wiring
- Outlet diameter to be drilled, according to the filter and length chosen (D200 to D400 mm, see table above)
- Compatibility with a built-in double-inlet centrifugal fan (3 m hood maximum) or a remote fan in an extraction fan box/roof extract fan for longer lengths
- Site access for receiving a pallet weighing up to 90 kg and assembly in 1 or 2 modules
To go with
Also discover our rectangular hood with a 1.2 m overhang, our special oven hood with a large overhang or our condensation hood for laundries.