Bare housing for 7/7, 7/9, 8/9 motors: the shell for building your own extraction fan box
The Ventilsogood bare housing is an empty galvanised steel shell designed to house a double-inlet centrifugal fan motor of type 7/7, 7/9 or 8/9, so you can build your own extraction fan box or supply air unit suited to your restaurant ventilation ducting or professional mechanical ventilation system.
Technical specifications
| Specification |
Value |
| Reference |
Caissonnu450 |
| Dimensions |
500 x 500 x 530 mm |
| Material |
Galvanised steel |
| Access |
1 door |
| Drilling |
Undrilled (inlet and outlet to be fitted) |
| Compatible motors |
7/7, 7/9, 8/9 or equivalent |
| Housing weight |
19 kg |
What is it used for?
This housing serves as the base for a motorised extraction fan box installed on a commercial kitchen hood line, but it works equally well for supply air as for extraction, depending on the orientation of the motor you fit. It can also be used as a simple plenum in a restaurant ventilation network or professional mechanical ventilation system, without a motor inside, to distribute or collect air ahead of a spigot connection.
Should you choose a 7/7, a 7/9 or an 8/9?
The housing stays the same whichever of these three motor sizes you choose: it is the airflow required for your installation that determines the motor choice, not the housing itself. For reliable sizing, base your choice on the length of your hood, the cooking power and the duct network (length, elbows), not just on a motor size.
Installation and connection
The housing is supplied undrilled: you will need flat spigots at the inlet and outlet to connect your ducting, these are not supplied as standard. This empty design leaves you free to position the motor and the spigots in whichever orientation best suits your ductwork, without being constrained by pre-drilled holes that might not match your installation.
Points to check before ordering
- Check that the intended double-inlet centrifugal fan motor (7/7, 7/9 or 8/9) matches your airflow requirements before purchase: the housing itself does not determine extraction performance.
- Order the inlet and outlet flat spigots separately, as the housing is supplied undrilled.
- Check the available space on site (height, width) before ordering: 500 x 500 x 530 mm must fit the intended location.
- Order the installation kit (gasket and fixings) to secure the motor inside the housing.
- The motor's electrical connections must be carried out by a qualified professional, as a condition of the warranty.
Pair with
Find other sizes of motorised extraction fan boxes if you are looking for a model already fitted with its motor.