Extra-flat VMC exhaust box, 1,500 m³/h, D315 mm, for tight ductwork
The extra-flat VMC exhaust box, 1,500 m³/h, D315 mm, generic reference BFSA, is a motorised fan unit designed for installations where ceiling height is limited: suspended ceilings, low lofts, cramped plant rooms. It can be used for extraction, supply or transfer ventilation, with a quoted airflow of 1,500 m³/h and a circular spigot of D 315 mm.
Technical specifications
| Generic reference |
BFSA |
| Airflow |
1,500 m³/h |
| Inlet/outlet diameter |
D 315 mm |
| Dimensions |
L 500 x D 460 x H 380 mm |
| Power supply |
230 V, single-phase + earth, 50 Hz |
| Current |
1.6 A |
| Power |
147 W |
| Material |
Galvanised steel sheet |
| Manufactured in |
France |
| Warranty |
1 year |
Use and compatibility
This VMC extraction fan box is intended for mechanical ventilation systems in commercial or multi-occupancy premises where headroom is limited. Its extra-flat design sets it apart from a standard extraction fan box or a roof fan, both of which take up more vertical space. It is designed for horizontal installation, indoors or outdoors, and its direct-drive motor/fan assembly keeps vibration and running noise to a minimum. The impulse-type fan, used on the D 315 and D 355 mm models, together with a motor fitted with built-in thermal overload protection, make up a unit designed to run reliably over the long term. In terms of compatibility, this BFSA fan box can replace equivalent models from Vim kmdt, Aldes vec, Atlantic critair or Franceair sirius ranges, provided you check the connection diameter and the available space beforehand.
Installation and connection
This unit must be installed horizontally only. The circular spigots are fitted with lip seals to make duct connection easier, and the feet are marked to guide fixing of the box. The removable cover, held in place with screws, gives easy access for maintenance. The 230 V single-phase + earth supply is fitted with a cable gland, and a local isolator switch comes pre-fitted and pre-wired. The electrical connection must be carried out by a qualified electrician, a condition required to maintain the warranty.
Points to check before ordering
- Check the diameter of your existing ductwork: this fan box is designed for a D 315 mm spigot, so adjust accordingly if your installation is in D 355 mm.
- Check the available height in your plenum or suspended ceiling before making your choice: this is the whole point of an extra-flat design.
- The 1,500 m³/h airflow is a catalogue reference figure: duct length, the number of elbows and the presence of filters will affect the actual airflow once installed.
- Confirm whether you need extraction, supply or transfer ventilation, as all three uses are possible with this same fan box.
- If you are replacing an existing unit (Aldes, Atlantic, Franceair), compare the overall dimensions and spigot diameter before ordering.
Recommended with
To limit noise transmission from the fan box into a suspended ceiling or adjoining room, consider the 2 m² self-adhesive acoustic insulation roll.