The T32 roof extract fan is a horizontal discharge roof fan designed for commercial kitchen hoods of 1 to 2 metres or for ventilating plant rooms, with a maximum airflow of 2,000 m³/h on a single-phase 230 V motor.
Roof fan 2,000 m³/h for commercial kitchen hoods or mechanical ventilation systems
This roof fan extracts smoke, steam and cooking odours out of the premises, with the motor located on the roof or facade. It is designed for stainless steel commercial hoods of 1 to 2 m, typically fitted with 2 to 3 filters.
Technical specifications
| Specification |
Value |
| Maximum airflow |
2,000 m³/h |
| Power supply |
230 V single-phase |
| Motor power |
250 W |
| Current |
0.68 A |
| Motor |
4 poles |
| Base frame dimensions |
550 x 550 mm |
| Height |
566 mm |
| Base inlet diameter |
280 mm |
| Recommended ducting |
Ø250 or Ø315 mm |
| Weight |
32 kg |
| Speed controller compatibility |
5 A minimum |
| Manufacturing |
France |
| Warranty |
1 year |
Use and hood compatibility
The T32 roof fan is known for being quiet and is suitable for small restaurants, snack bars, fish and chip shops, or for mechanical ventilation of industrial premises. It is ideal for a hood measuring 1 to 2 m with 2 to 3 filters. The single-phase 230 V motor makes installation easier in premises without a three-phase supply.
It includes a bird protection guard and a factory-wired isolator switch mounted on the unit. Its speed can be adjusted using a single-phase speed controller rated at 5 A minimum, to match the extraction rate to kitchen usage.
Installation and connection
Connection is made to a Ø250 or Ø315 mm ductwork system, depending on duct length and number of elbows: a Ø315 mm diameter reduces pressure losses and noise on longer runs or those with several changes of direction. The larger the diameter, the better the airflow.
Installation requires correctly sized thermal overload protection suited to the motor, as well as a dedicated electrical supply line. VentilSoGood sells this roof fan but does not carry out installation: fitting and connection must be carried out by a qualified professional.
Points to check before ordering
- Length of the hood and number of filters (2 to 3 filters for a hood of 1 to 2 m, as a guide).
- Diameter and length of the existing ductwork, number of elbows: a Ø250 mm may become a limiting factor on a long run, while Ø315 mm reduces pressure losses.
- Type of power supply available on site: this roof fan is single-phase 230 V, a three-phase version exists for 400 V installations.
- Presence of a dedicated electrical line and thermal overload protection suited to the motor, a condition for the professional warranty.
- Reference of the roof fan being replaced (Aldes Velone, Alvene EMMOS, France Air SIMOUN, VIM TEDH among others), to be compared specification by specification before ordering.
Recommended with
For a three-phase installation, see the T32 TRI roof extract fan, 2,000 m³/h. For a higher airflow, see the T25 roof fan, 2,500 m³/h 230 V. Browse the full range on our roof fans page.